-Replace existing bulbs easily without wiring changes -One bulb gives constant ON or flashing strobe with your existing single switch -Constant ON mode is day or night legal, strobe mode gives increased visibility during the day, used at pilot's discretion (constant ON required at night)
-Drastic power reduction from 7A typical for three incandescent bulbs to under 1A with 3 LED bulbs -Increased bulb life and lifetime cost savings by switching to LED -Designed to meet TSO-C-30c and FAA AC20-74 requirements -Wingtip bulbs are 30W Red or Green LEDs. Tail bulb is 7.5W white
These bulbs can be used to replace your existing 28W nav light bulbs including Whelen W1290, Grimes A7512-12, Rapco WL1512, AML7512, UA1512, and several others. Tail light bulb can be used to replace any standard bulb with a BAY15S base. No wiring changes are necessary. Turn on the switch and they light up in a constant mode. Quickly turn off and back on again and they switch to a strobe mode. Strobe mode does not meet the anti-collision light requirements for night use, but they do meet the nav light requirements day or night and the strobe mode increases the ability to see them during the day. They are auto voltage sensing so they can be used on either 12V or 24V systems.
AIRSTREAM C CHANNEL
RIVET SPACING TOOL
AIRSTREAM ALUMINUM EXTERIOR
CLECO KIT 5/32"
HS310-5B SHAVING TOOL FOR 5/32 OLYMPIC RIVETS
RIVET REMOVAL TOOL
3x Rivet Gun Kit Red Box 737
The Claw Aircraft Tie Down
CABLE THIMBLE AN100
CLECO FASTENER (CLECOS)
AIRSTREAM ALUMINUM BELLY PAN
CONTROL CABLE
2024T3 Alclad Aluminum Sheet and Coil
